by bartonmd » Wed Aug 24, 2011 4:55 pm
Especially with it only being 1/8 thick, I would put the braces on the sides... makes it have to deformed the plate to bend it in 2 directions at once, rather than just bowing it up in the middle when you just support it front and back...
Cut a couple wedges 2.5 long, and 1/4 in front and 3/8 in rear, and weld them to the sides, for support...
Also, since you are using flux core, a you might want to take your slag off before you paint, as it will come off the first thing you touch with it...
otherwise, looks good!
Mike